| 滴灌带短路解决方法是什么 |
| 添加时间：2019/11/16 16:14:29 浏览次数： |
| 一、短路点的顶部可以用绝缘材料隔开，也可以将绝缘线重新包好并涂漆。 I. the top of the short circuit point can be separated by insulating material, or the insulating wire can be wrapped and painted again. 二、滴灌带设备线槽短路。软化后，找出短路点，进行修理，然后放入线槽内，涂刷油漆并烘干。 II. Short circuit in the equipment trunking of drip irrigation belt. After softening, find out the short circuit point, repair it, then put it into the trunking, paint and dry it. 三、每相绕组短路小于1/12匝。串联匝间时，切断所有电源，并将连接处与武汉网站连接，形成闭路。它可以在紧急情况下使用。 III. The short circuit of each phase winding is less than 1 / 12 turn. When connecting turns in series, cut off all power supply and connect the connection with Wuhan website to form a closed circuit. It can be used in an emergency. 四。滴灌带绕组短路点匝数超过1/12匝时，应全部拆除并重新缠绕。 Four. When the number of turns of the short-circuit point of the drip band winding exceeds 1 / 12 of the turns, it shall be completely removed and rewound. |
| 上一页 设备安装完毕后需要重点检查和调整的部位 |
| 下一页 滴灌栽培播种以穴播或半精量播种为主 |
Copyright © 技术支持：遨游网络