贴片式滴灌带安装
Patch type drip irrigation belt installation
滴灌用水一般经过首部枢纽稳压、过滤、施肥，再通过干管、支管，最后由滴灌带滴到植物的根部。
The drip irrigation water is usually stabilized, filtered and fertilized through the first part of the hub, and then dries through the trunk and branch pipes, and finally drops from the drip irrigation belt to the roots of the plant.
滴灌带的安装分以下几个步骤进行：
The installation of the drip irrigation belt is carried out in the following steps:
1、在支管上打孔
1. Drilling on a branch pipe
在PE管，PVC管，输水带支管上先用专用打孔工具进行打孔。
In the PE pipe, PVC pipe and the branch pipe of the water conveyance belt, the special drilling tool is used to punch holes.
2、输水管与滴灌带相连
2. The water pipe is connected to the drip irrigation zone
用专用旁通将输水支管与滴灌带连在一起。
The water conveyance branch is connected with drip irrigation belt by special bypass.
3、清洗与封头
3, cleaning and sealing the head
滴灌带与输水管按照步骤1、2安装完毕后要打开输水阀门进行冲洗，将系统及滴灌带中存留的杂质颗粒冲洗掉，最后将滴灌带尾端翻卷两折，用剪断的滴灌带头将末端封住。也可以直接使用堵头直接封住
The drip irrigation belt and water pipe should be flushed after the installation of steps 1 and 2. The system and the impurity particles in the drip irrigation belt are flushed out. Finally, the tail end of the drip irrigation band is rolled up eighty percent off, and the end is sealed with the cut drip irrigation head. It can also be directly sealed with a plug.